Table of Contents
Advertisement
B3(su)->show logout
Logout currently set to: 10 minutes.
set logout
Use this command to set the time (in minutes) an idle console or Telnet CLI session will remain
connected before timing out.
Syntax
set logout timeout
Parameters
timeout
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the system timeout to 10 minutes:
B3(su)->set logout 10
show console
Use this command to display console settings.
Syntax
show console [baud] [bits] [flowcontrol] [parity] [stopbits]
Parameters
baud
bits
flowcontrol
parity
stopbits
Defaults
If no parameters are specified, all settings will be displayed.
Mode
Switch command, read‐only.
Sets the number of minutes the system will remain idle before timing out.
(Optional) Displays the input/output baud rate.
(Optional) Displays the number of bits per character.
(Optional) Displays the type of flow control.
(Optional) Displays the type of parity.
(Optional) Displays the number of stop bits.
SecureStack B3 Configuration Guide 3-25
set logout
Advertisement
Table of Contents
