Defaults
If no port string is entered, all ports a will be reset to default configuration with VLAN
authorization disabled and egress frames untagged.
Mode
Switch command, read‐write.
Example
This example show how to clear VLAN authorization for all ports on slots 3, 4, and 5:
B3(rw)->clear vlanauthorization ge.3-5.*
show vlanauthorization
Displays the VLAN authentication status and configuration information for the specified ports.
Syntax
show vlanauthorization [port-string]
Parameters
port‐string
Defaults
If no port string is entered, the status for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This command shows how to display VLAN authorization status for ge.1.1:
B3(rw)-> show vlanauthorization ge.1.1
port
-----
ge.1.1
Table
20‐5 provides an explanation of command output. For details on enabling and assigning
protocol and egress attributes, refer to "set vlanauthorization" on page
vlanauthorization egress" on page 20‐44.
Table 20-5 show vlanauthorization Output Details
Output
port
status
(Optional) Displays VLAN authentication status for the specified ports. If
no port string is entered, then the global status of the setting is displayed.
For a detailed description of possible port‐string values, refer to "Port
String Syntax Used in the CLI" on page 5‐1.
status
administrative egress
-------
-------------------------
enabled
untagged
What It Displays...
Port identification
Port status as assigned by set vlanauthorization command
show vlanauthorization
operational egress
---------------------
none
20‐43 and "set
SecureStack B3 Configuration Guide 20-45
vlan id
--------
0
Need help?
Do you have a question about the SecureStack B3 and is the answer not in the manual?