Set Logging Application; Show Logging Application Output Details - Enterasys SecureStack B3 Configuration Manual

Example
This example shows how to display system logging information pertaining to the SNMP
application.
B3(ro)->show logging application SNMP
Application
---------------------------------------------
90
1(emergencies)
4(errors)
7(information)
Table 13‐2 provides an explanation of the command output.
Table 13-2 show logging application Output Details
Output...
Application
Current Severity Level

set logging application

Use this command to set the severity level of log messages for one or all applications.
Syntax
set logging application {[mnemonic | all]} [level level]
Parameters
mnemonic
all
Current Severity Level
SNMP
2(alerts)
5(warnings)
8(debugging)
Specifies a case sensitive mnemonic abbreviation of an application to be
logged. This parameter will vary depending on the number and types of
applications running on your system. To display a complete list, use the
show logging application command as described in "show logging
application" on page 13‐6. Sample mnemonics and their corresponding
applications are listed in Table
Note: Mnemonic values are case sensitive and must be typed as they appear in
Table 13-3.
Sets the logging severity level for all applications.
6
3(critical)
6(notifications)
What it displays...
A mnemonic abbreviation of the textual description for
applications being logged.
Severity level at which the server is logging messages for the
listed application. This range (from 1 to 8) and its associated
severity list is shown in the CLI output. For a description of these
entries, which are set using the set logging application
command, refer to "set logging
13‐3 on page 13‐8.
set logging application
application" on page 13-7.
SecureStack B3 Configuration Guide 13-7