Table of Contents
Advertisement
padminstate
lacpactive |
lacptimeout |
lacpagg | lacpsync
| lacpcollect |
lacpdist | lacpdef |
lacpexpire | all
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear all link aggregation parameters for port
B3(su)->clear port lacp port ge.3.16
Configuring Protected Ports
The Protected Port feature is used to prevent ports from forwarding traffic to each other, even
when they are on the same VLAN. Ports may be designated as either protected or unprotected.
Ports are unprotected by default. Multiple groups of protected ports are supported.
Protected Port Operation
Ports that are configured to be protected cannot forward traffic to other protected ports in the
same group, regardless of having the same VLAN membership. However, protected ports can
forward traffic to ports which are unprotected (not listed in any group). Protected ports can also
forward traffic to protected ports in a different group, if they are in the same VLAN. Unprotected
ports can forward traffic to both protected and unprotected ports. A port may belong to only one
group of protected ports.
This feature only applies to ports within a switch. It does not apply across multiple switches in a
network.
Commands
For information about...
set port protected
show port protected
clear port protected
set port protected name
show port protected name
clear port protected name
Clears the port's specific partner admin state, or all partner admin state(s).
Configuring Protected Ports
.3.16:
ge
Refer to page...
5-48
5-48
5-49
5-49
5-50
5-50
SecureStack B3 Configuration Guide 5-47
Advertisement
Table of Contents
