Table of Contents
Advertisement
Downloading via the Serial Port
To download switch firmware via the serial (console) port, proceed as follows:
1.
With the console port connected, power up the switch. The following message displays:
Version 01.00.29 05-09-2005
Computing MD5 Checksum of operational code...
Select an option. If no selection in 2 seconds then
operational code will start.
1 - Start operational code.
2 - Start Boot Menu.
Select (1, 2):2
Password: *************
2.
Before the boot up completes, type 2 to select "Start Boot Menu". Use "administrator" for the
Password.
Note: The above "Boot Menu" password "administrator" can be changed using boot menu option
11.
Boot Menu Version 01.00.29 05-09-2005
Options available
1
- Start operational code
2
- Change baud rate
3
- Retrieve event log using XMODEM (64KB).
4
- Load new operational code using XMODEM
5
- Display operational code vital product data
6
- Run Flash Diagnostics
7
- Update Boot Code
8
- Delete operational code
9
- Reset the system
10 - Restore Configuration to factory defaults (delete config files)
11 - Set new Boot Code password
[Boot Menu] 2
3.
Type 2. The following baud rate selection screen displays:
1 - 1200
2 - 2400
3 - 4800
4 - 9600
5 - 19200
6 - 38400
7 - 57600
8 - 115200
0 - no change
4.
Type 8 to set the switch baud rate to 115200. The following message displays:
Setting baud rate to 115200, you must change your terminal baud rate.
5.
Set the terminal baud rate to 115200 and press ENTER.
Downloading a New Firmware Image
SecureStack B3 Configuration Guide 3-35
Advertisement
Table of Contents
