Statistics Group Commands; Show Rmon Stats - Enterasys SecureStack B3 Configuration Manual

Statistics Group Commands

Purpose
To display, configure, and clear RMON statistics.
Commands
For information about...

show rmon stats

set rmon stats
clear rmon stats
show rmon stats
Use this command to display RMON statistics measured for one or more ports.
Syntax
show rmon stats [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, RMON stats will be displayed for all ports.
Mode
Switch command, read‐only.
Example
This example shows how to display RMON statistics for Gigabit Ethernet port 1 in switch 1.
:
B3(su)->show rmon stats ge.1.1
Port: ge.1.1
-------------------------------------
Index
Owner
Data Source
Drop Events
Collisions
Jabbers
Broadcast Pkts
Note: Due to hardware limitations, the only frame error counted is oversized frames.
(Optional) Displays RMON statistics for specific port(s).
= 1
= monitor
= ifIndex.1
= 0 Packets
= 0 Octets
= 0 0
= 0 65
= 0
= 0
- 64 Octets = 0
- 127 Octets = 0
Statistics Group Commands
Refer to page...
14-3
14-4
14-4
SecureStack B3 Configuration Guide 14-3