No Auto-Summary - Enterasys SecureStack B3 Configuration Manual

no auto-summary

Parameters
keyid
md5
key
Mode
Interface configuration: B3(su)‐>router(Config‐if(Vlan 1))#
Defaults
None.
Examples
This example shows how to set the MD5 authentication ID to 5 for the RIP authentication key set
on the VLAN 1 interface:
B3(su)->router(Config)#interface vlan 1
B3(su)->router(Config-if(Vlan 1))#ip rip message-digest-key 5 md5 password
no auto-summary
Use this command to disable automatic route summarization.
Syntax
no auto-summary
auto-summary
Parameters
None.
Defaults
None.
Mode
Router configuration: B3(su)‐>router(Config‐router)#
Usage
By default, RIP version 2 supports automatic route summarization, which summarizes
subprefixes to the classful network boundary when crossing network boundaries. Disabling
automatic route summarization enables CIDR, allowing RIP to advertise all subnets and host
routing information on the SecureStack B3 device. To verify which routes are summarized for an
interface, use the show ip route command as described in "show ip route" on page 17‐13. The
reverse of the command re‐enables automatic route summarization.
18-6 IPv4 Routing Protocol Configuration
Specifies the key ID to enable or disable for RIP authentication. Valid values
are 1 to 255.
Specifies use of the MD5 algorithm.
Specifies the RIP authentication password.
Note: This command is necessary for enabling CIDR for RIP on the SecureStack B3 device.