Set Switch Copy-Fw; Set Switch Description - Enterasys SecureStack B3 Configuration Manual

set switch copy-fw

set switch copy-fw
Use this command to replicate the code image file from the management switch to other
switch(es) in the stack.
Syntax
set switch copy-fw [destination-system unit]
Parameters
destination‐system
unit
Defaults
If destination‐system is not specified, the management image file will be replicated to all switches
in the stack.
Mode
Switch command, read‐write.
Example
This example shows how to replicate the management image file to all switches in the stack:
B3(su)->set switch copy-fw
Are you sure you want to copy firmware? (y/n) y
Code transfer completed successfully.

set switch description

Use this command to assign a name to a switch in the stack.
Syntax
set switch description unit description
Parameters
unit
description
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to assign the name "FirstUnit" to switch unit 1 in the stack:
B3(su)->set switch description 1 FirstUnit
2-10 Configuring Switches in a Stack
(Optional) Specifies the unit number of unit on which to copy the
management image file.
Specifies a unit number for the switch.
Specifies a text description for the unit.