Enterasys SecureStack B3 Configuration Manual page 330

set policy profile
Parameters
profile‐index
name name
pvid‐status
enable | disable
pvid pvid
cos‐status enable
| disable
cos cos
egress‐vlans
egress‐vlans
forbidden‐vlans
forbidden‐vlans
untagged‐vlans
untagged‐vlans
append
clear
precedence
precedence‐list
If optional parameters are not specified, none will be applied.
Mode
Switch command, read‐write.
Example
This example shows how to create a policy profile 1 named "netadmin" with PVID override
enabled for PVID 10, and Class‐of‐Service override enabled for CoS 5. This profile can use VLAN
10 for untagged egress:
B3(su)->set policy profile 1 name netadmin pvid-status enable pvid 10 cos-status
enable cos 5 untagged-vlans 10
10-4 Policy Classification Configuration
Specifies an index number for the policy profile. Valid values are 1 ‐ 255.
(Optional) Specifies a name for the policy profile. This is a string from 1 to
64 characters.
(Optional) Enables or disables PVID override for this profile. If all
classification rules associated with this profile are missed, then this
parameter, if specified, determines default behavior.
(Optional) Specifies the PVID to packets, if PVID override is enabled and
invoked as default behavior.
(Optional) Enables or disables Class of Service override for this profile. If all
classification rules associated with this profile are missed, then this
parameter, if specified, determines default behavior.
(Optional) Specifies a CoS value to assign to packets, if CoS override is
enabled and invoked as default behavior. Valid values are 0 to 7.
(Optional) Specifies that the port to which this policy profile is applied
should be added to the egress list of the VLANs defined by egress‐vlans.
Packets will be formatted as tagged.
(Optional) Specifies that the port to which this policy profile is applied
should be added as forbidden to the egress list of the VLANs defined by
forbidden‐vlans. Packets from this port will not be allowed to participate in
the listed VLANs.
(Optional) Specifies that the port to which this policy profile is applied
should be added to the egress list of the VLANs defined by untagged‐vlans.
Packets will be formatted as untagged.
(Optional) Appends this policy profile setting to settings previously
specified for this policy profile by the egress‐vlans, forbidden‐vlans, or
untagged‐vlans parameters.
If append is not used, previous VLAN settings are replaced.
(Optional) Appends this policy profile setting from settings previously
specified for this policy profile by the egress‐vlans, forbidden‐vlans, or
untagged‐vlans parameters.
(Optional) Assigns a rule precedence to this profile. Lower values will be
given higher precedence. For a list of values, refer to the show policy
profile command output.