Table of Contents
Advertisement
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the system's hardware configuration. Please note that the
information you see displayed may differ from this example.
B3(su)->show system hardware
SLOT HARDWARE INFORMATION
--------------------
Model:
Serial Number:
Vendor ID:
Base MAC Address:
Hardware Version:
FirmWare Version:
Boot Code Version:
show system utilization
Use this command to display detailed information about the processor running on the switch, or
the overall memory usage of the Flash and SDRAM storage devices on the unit, or the processes
running on the switch. Only the memory usage in the master unit of a stack is shown.
Syntax
show system utilization {cpu | storage | process}
Parameters
cpu
storage
process
Defaults
None.
Mode
Switch command, read‐only.
B3G124-24
041800129041
0x0e10
00:01:F4:5F:1D:E0
BCM56504 REV 19
1.1.xx
01.00.17
Display information about the processor running on the switch.
Display information about the overall memory usage on the switch.
Display information about the processes running on the switch.
show system utilization
SecureStack B3 Configuration Guide 3-13
Advertisement
Table of Contents
