Table of Contents
Advertisement
show cos port-config
show cos port-config
Use this command to show inbound rate limiting groups and the assigned ports.
Syntax
show cos port-config [irl group-type-index]
Parameters
irl
group‐type‐index
Defaults
The show cos port‐config command by itself will show all Port Groups.
Mode
Switch command, read‐only.
Example
This example shows all inbound rate limiting port groups. Note that ports
were removed from the default port group 0.0 when they were added to port groups 1.0 and 2.0.
B3(su)->show cos port-config
Inbound Rate Limiting Port Configuration Entries
----------------------------------------------------------------------
Port Group Name
Port Group
Port Type
Assigned Ports
----------------------------------------------------------------------
Port Group Name
Port Group
Port Type
Assigned Ports
----------------------------------------------------------------------
Port Group Name
Port Group
Port Type
Assigned Ports
----------------------------------------------------------------------
clear cos port-config
Use this command to clear inbound rate limiting groups or assigned ports.
Syntax
clear cos port-config irl {all | group-type-index {[entry] | [name] [ports]}}
10-24 Policy Classification Configuration
(Optional) Specifies that inbound rate limiting configuration information
should be displayed.
(Optional) Show assigned ports for a specific port group. Valid entries are
in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
:Default
:0
:0
:none
:Users
:1
:0
:ge.1.1-46
:Uplink
:2
:0
:ge.1.47-48
.1.1 through
.1.48
ge
ge
Advertisement
Table of Contents
