Table of Contents
Advertisement
This chapter describes the IPv4 Routing Protocol Configuration set of commands and how to use
them.
For information about...
Configuring RIP
Configuring IRDP
Configuring RIP
Purpose
To enable and configure the Routing Information Protocol (RIP).
RIP Configuration Task List and Commands
Table
18‐1 lists the tasks and commands associated with RIP configuration. Commands are
described in the associated section as shown.
Table 18-1 RIP Configuration Task List and Commands
To do this...
Enable RIP configuration mode.
Enable RIP on an interface.
Configure an administrative distance.
Allow reception of a RIP version.
Allow transmission of a RIP version.
Configure RIP simple authentication.
Configure RIP encrypted authentication.
Disable automatic route summarization
(necessary for enabling CIDR)
IPv4 Routing Protocol Configuration
Router: The commands covered in this chapter can be executed only when the device is in router
mode. For details on how to enable router configuration modes, refer to
Configuration
Modes" on page 16-2.
Use these commands...
"router
rip" on page 18-2
"ip rip
enable" on page 18-2
"distance" on page 18-3
"ip rip send
version" on page 18-4
"ip rip receive
version" on page 18-4
"ip rip
authentication-key" on page 18-5
"ip rip
message-digest-key" on page 18-5
"no
auto-summary" on page 18-6
SecureStack B3 Configuration Guide 18-1
18
"Enabling Router
Refer to page...
18-1
18-9
Advertisement
Table of Contents
