Table of Contents
Advertisement
Table 4-4 show lldp port local-info Output Details (Continued)
Output Field
PoE Pair Controllable/Used
PoE Power Class
PoE Power Limit (mW)
PoE Power Priority
show lldp port remote-info
Use this command to display the remote system information stored for a remote device connected
to a local port. You can use this information to detect misconfigurations or incompatibilities
between the local port and the attached endpoint device (remote port).
Syntax
show lldp port remote-info [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, remote system information will be displayed for all ports.
Mode
Switch command, read‐only.
What it Displays...
IEEE 802.3 Extensions Power via MDI TLV. Displayed only when a port
has PoE capabilities. Indicates whether pair selection can be controlled
on the given port (refer to RFC 3621). Value for Controllable can be true
or false. Value of Used can be signal (signal pairs only are in use) or
spare (spare pairs only are in use).
IEEE 802.3 Extensions Power via MDI TLV. Displayed only when a port
has PoE capabilities. Indicates the power class supplied by the port.
Value can range from 0 to 4.
LLDP-MED Extensions Extended Power via MDI TLV. Displayed only
when a port has PoE capabilities. Indicates the total power the port is
capable of sourcing over a maximum length cable, based on its current
configuration, in milli-Watts.
LLDP-MED Extensions Extended Power via MDI TLV. Displayed only
when a port has PoE capabilities. Indicates the power priority configured
on the port. Value can be critical, high, or low.
(Optional) Displays remote system information for one or a range of
ports.
show lldp port remote-info
SecureStack B3 Configuration Guide 4-21
Advertisement
Table of Contents
