Stacking Commands; Config Box_Id; Show Stack_Information - D-Link DGS-3100 Series Cli Manual

The Stacking commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command

config box_id

show stack_information

config box_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To change the unit ID from 1 to 2:
show stack_information
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display information about units in the stack:
Parameter
current_box_id <value 1-6> new_box_id [auto | 1 | 2 | 3 | 4 | 5 | 6]
To change the unit ID (stack membership number).
config box_id current_box_id <value 1-6> new_box_id [auto | 1 |
2 | 3 | 4 | 5 | 6]
The config box_id command changes the unit ID (stack
membership number). The command takes effect only after
rebooting the device.
current_box_id <value 1-6> - Specifies the unit's current stack
membership number.
new_box_id <auto | 1 | 2 | 3 | 4 | 5 | 6> - Specifies the units's new
stack membership number. If auto is specified, the system
automatically defines the unit's new ID.
Only administrator-level users can issue this command.
DGS3100# config box_id 1 new_box_id 2
DGS3100#
To display information about the units in the stack.
show stack_information
The show stack_information command displays information about
the units in the stack, including the unit numbers, firmware version,
hardware version, Master ID and Backup ID.
None.
None.
S
TACKING
157
28
C
OMMANDS