Tieline Merlin PLUS User Manual page 48

48 Merlin PLUS WNET Manual v2.0
Important Note: If a B channel has been selected within another Config it will not be
visible. Only available B channels are displayed.
6. Select the bonding method if multiple B channels have been selected, then press the
7. Select Disable when connecting to Tieline codecs using session data, or select Enable if
connecting to non-Tieline codecs only, then press the
Important Note: Select Disable if the codec is expected to receive ISDN calls from
Tieline codecs, or both Tieline and non-Tieline codecs (i.e. you are not sure which type of
codec may call). In this mode, once the codec answers a call, it expects to receive
Tieline session data from the caller and configure its own algorithm settings according to
that. If it fails to receive Tieline session data within 5 seconds (i.e. a non-Tieline codec is
calling, or a Tieline codec with session data disabled), it will use the settings in the ISDN
Answering Config instead.
Enable Sessionless Only when answering ISDN calls from non-Tieline codecs only.
When Sessionless is configured, the codec will not wait for the session data. This
reduces the time taken to answer an inbound sessionless call.
8. Select the default algorithm when receiving a call from a non-Tieline codec, then press the
button.
9. Specify the audio stream Route when receiving a call on the answering codec from a non-
Tieline codec, then press the
10. Select Yes and then press the
button.
button to confirm all changes.
button.
© Tieline Pty. Ltd. 2017
button.