Tieline Merlin PLUS User Manual page 170

170 Merlin PLUS WNET Manual v2.0
Next, enter the phone number of the codec or device you want to dial. When multiple
POTS modules are installed, click the Via drop-down menu and select Module 1 or
Module 2 to specify which POTS module will dial. Next, click Save Program to save
the program with default settings, or click Next to specify algorithm settings and
configure a backup connection if required (recommended).
Dialing configuration settings for this POTS audio stream are now complete.
Configuring a Failover Connection or Auto Reconnect
At this point in the wizard you can choose to configure Auto Reconnect or create a failover
connection for the audio stream you are configuring.
Important Note: When Auto Reconnect is enabled, the dialing codec will continue to
attempt a connection with the remote codec until Disconnect is pressed either on the
dialing codec's keypad, or in the Web-GUI.
To configure a backup connection:
1. Click to select the check-box for Create a Failover Connection. Adjust the parameters
and click Next.
© Tieline Pty. Ltd. 2017