Tieline Merlin PLUS User Manual page 282

282 Merlin PLUS WNET Manual v2.0
FEC Setting
100%
(Lowest
delay)
50%
33%
25%
20%
10%(Highest
delay)
Off
Configuring Tieline FEC in the Codec
1. Press the HOME
2. Use the navigation buttons on the front panel to select Connect and press the
3. Select IP and press the
4. Select Tieline and press the
5. Use the down
6. Navigate to FEC and press
7. Select the local codec FEC setting in the Local FEC screen and press
Bit rate Ratios
A simultaneous dual-redundant
stream (1:1 ratio) is sent from
the codec. Twice
connection bit rate is required to
operate the codec using the
100% setting. E.g.
connection is 14,400Kbps, you
will require an additional 14,400
Kbps of bandwidth to allow for
the FEC data stream.
Additional data is sent by FEC
in a ratio of 2:1.
Additional data is sent by FEC
in a ratio of 3:1.
Additional data is sent by FEC
in a ratio of 4:1.
Additional data is sent by FEC
in a ratio of 5:1.
Additional data is sent by FEC
in a ratio of 10:1.
FEC is off in the codec and the
connection bandwidth is equal
to the connection
setting in the codec.
button to return to the Home screen.
button.
button.
navigation button to select Setup and press the
.
Connection Use
Recommended to
be used
the wireless
international
connections.
if your
Recommended for
international
national
connections
Recommended for
national and local
connections.
Recommended for
national and local
connections.
Recommended for
local and
connections.
Recommended for
local and
connections.
Recommended for
wired
bit rate connections
managed T1 & E1
connections
STLs
connections that
aren't shared &
have quality
service (QoS).
Tieline RFC
FEC 2733
FEC
Yes Yes
over
and
Yes Yes
&
Yes Yes
No Yes
Yes Yes
LAN
No Yes
LAN
Yes Yes
LAN
&
for
with
of
button.
button.
.
© Tieline Pty. Ltd. 2017