Ip Via Mapping - Tieline Merlin PLUS User Manual

260 Merlin PLUS WNET Manual v2.0
5. Select Usage and press the
6. Select the mode of operation for this VLAN (e.g. Control & Streaming, Streaming only,
Control Only) and press the
7. Use the down
8. Press the
9. Press the
VLAN Interface (VLAN configuration only)
This setting applies the VLAN settings to a physical Ethernet port in the codec.
1. Press the SETTINGS
2. Use the navigation buttons on the front panel to select Network and press the
3. Use the down
4. Navigate to Config and press the
5. Select Usage and press the
6. Select the mode of operation for this VLAN (e.g. Control & Streaming, Streaming only,
Control Only) and press the
7. Use the down
8. Press the
24.2

IP Via Mapping

When dialing over IP you can select the preferred interface to use when establishing a connection.
By default Any is selected, which means the first available interface will be used to dial a
connection. The default Via interfaces in order of use when available are:
1. ETH1 Ethernet port (default Primary Via interface)
2. ETH2 Ethernet port (default Secondary Via interface)
3. Wi-Fi (default Tertiary Via interface)
Important Notes:
·
If an interface is not available it is not listed in the Via interface selection screen. E.g. if
Wi-Fi is not configured it will be unavailable.
·
If you select Fuse-IP as the Via interface, a link to the Fuse-IP configuration menu
appears above the Via menu.
·
VLAN interfaces have features similar to physical Ethernet interfaces. However, your
network administrator will need to configure VLAN support throughout your network for
them to be supported in your codec.
Reconfigure Default Primary, Secondary and Tertiary Interfaces
It is possible to reconfigure the default Primary (Ethernet 1), Secondary (Ethernet 2) and
Tertiary (Wi-Fi) interfaces in the codec. As an example, you may want to select Primary as
the dialing interface in a program and then copy this program onto multiple codecs. However,
the actual primary interface used at each location can vary for each codec. For one codec it
button.
button.
navigation button to scroll to VLAN Priority.
button to enter a number from 0 to 7 inclusive.
button to confirm this setting.
button.
navigation button to select a VLAN interface and press the
button.
button.
navigation button to scroll to Interface.
button to select ETH1 or ETH2, then press the
button
button.
button.
button.
© Tieline Pty. Ltd. 2017