Tieline Merlin PLUS User Manual page 125

network for them to be supported in your codec.
Reconfigure Default Primary, Secondary and Tertiary Interfaces
It is possible to reconfigure the default Primary (ETH1), Secondary (ETH2) and Tertiary (Wi-
Fi) interfaces in the codec. As an example, you may want to select Primary as the dialing
interface in a program and then copy this program onto multiple codecs. However, the actual
primary interface used at each location can vary for each codec. For one codec it may be an
Ethernet interface and for another it may be a Wi-Fi connection. This allows you to configure
site-specific settings to suit the available network interfaces at different remote locations.
1. Open the HTML5 Toolbox Web-GUI and click Transport and then click IP Via
2. Click the drop-down arrow for each interface to select the preferred default setting.
3. Click Save to store the configuration.
Important Note: Fuse-IP cannot be configured as a default Primary, Secondary or
Tertiary Via.
Configuring QoS
1. Open the HTML5 Toolbox Web-GUI and click Settings and then click Options to open the
Options panel.
2. Click in the DSCP field and enter the priority setting recommended by your IT administrator.
3. Click Save to store configuration settings.
© Tieline Pty. Ltd. 2017
Mapping to open this panel.
Merlin PLUS WNET Manual v2.0 125