Tieline Merlin PLUS User Manual page 142

142 Merlin PLUS WNET Manual v2.0
POTS Config Settings
The default POTS Answer module Config settings, which can be viewed in the POTS Answer
panel are:
·
Tieline Codecs Session Data.
·
The Other algorithm.
This configuration will accept the settings from an incoming Tieline codec when it dials with
session data enabled. It will also allow the codec to answer a call from a Comrex POTS codec
supporting the Other algorithm setting.
To reset POTS answering to default settings click the Options symbol in the top right-hand corner
of the panel and select Reset all to factory defaults.
Answering Calls from Non-Tieline POTS Codecs
1. Open the HTML5 Toolbox Web-GUI and click Transport and then POTS Answer.
2. Click the Edit button to configure settings.
3. Select the Sessionless Only check-box when only non-Tieline codecs are dialing a Tieline
codec over POTS. This allows you to select the default encoding setting and Route the
incoming call to a nominated audio stream via a corresponding Answer Route in the answering
codec program if required.
© Tieline Pty. Ltd. 2017