Adding An Ipv6 Acl - HP FlexNetwork NJ5000 User Manual

Item
Filter
COS(802.1p priority)
Type Filter
Time Range

Adding an IPv6 ACL

Select QoS > ACL IPv6 from the navigation tree.
1.
Click the Add tab.
2.
The IPv6 ACL configuration page appears.
Figure 433 Adding an IPv6 ACL
Add an IPv6 ACL.
3.
Click Apply.
4.
Table 138 Configuration items
Item
ACL Number
Description
Source Mask
Destination MAC
Select the Destination MAC Address box and enter a destination MAC
Address
address and a mask.
Destination Mask
Specify the 802.1p priority for the rule.
Select the LSAP Type box and specify the DSAP and SSAP fields in the
LSAP Type
LLC encapsulation by configuring the following items:
•
LSAP Mask
•
Protocol Type Select the Protocol Type box and specify the link layer protocol type by
configuring the following items:
•
Protocol Mask
•
Select the time range during which the rule takes effect.
Description
Enter a number for the IPv6 ACL.
LSAP Type—Frame encapsulation format.
LSAP Mask—LSAP mask.
Protocol Type—Frame type. It corresponds to the type-code field of
Ethernet_II and Ethernet_SNAP frames.
Protocol Mask—Protocol mask.
393