Poe Configuration Example - HP FlexNetwork NJ5000 User Manual

Figure 475 PoE summary (with GigabitEthernet 1/0/3 selected)

PoE configuration example

Network requirements
As shown in
telephones.
The IP telephones have a higher power supply priority than the AP so the PSE supplies power to the
IP telephones first if the PSE power is overloaded.
Figure 476 Network diagram
Configuring PoE
Enable PoE on GigabitEthernet 1/0/3:
1.
a. Select PoE > PoE from the navigation tree.
b. Click the Setup tab.
c. On the tab, click to select ports GigabitEthernet 1/0/3 from the chassis front panel, and then
select Enable from the Power State list.
d. Click Apply.
Figure 476, GigabitEthernet 1/0/3 and GigabitEthernet 1/0/4 are connected to IP
433