HP FlexNetwork NJ5000 User Manual page 409

Item
Check Logging
Source IP Address
Source Prefix
IP
Address
Filter
Destination IP Address
Destination Prefix
Protocol
Named ICMPv6 Type
ICMPv6 Type
ICMPv6
Type
ICMPv6 Code
Operator
Source Port
To Port
Operator
TCP/UD
Port
P Port
Destinat
ion
To Port
Time Range
Description
Select this box to keep a log of matched IPv6 packets.
A log entry contains the ACL rule number, operation for the matched
packets, protocol number, source/destination address,
source/destination port number, and number of matched packets.
This function is not supported.
Select the Source IP Address box and enter a source IPv6 address
and prefix length.
The IPv6 address must be in a format like X:X::X:X. An IPv6 address
consists of eight 16-bit long fields, each of which is expressed with
two hexadecimal numbers and separated from its neighboring fields
by colon (:).
Select the Destination IP Address box and enter a destination IPv6
address and prefix length.
The IPv6 address must be in a format like X:X::X:X. An IPv6 address
consists of eight 16-bit long fields, each of which is expressed with
two hexadecimal numbers and separated from its neighboring fields
by colon (:).
Select the protocol number.
If you select 58 ICMPv6, you can configure the ICMP message type
and code. If you select 6 TCP or 17 UDP, you can configure the TCP
or UDP specific items.
Specify the ICMPv6 message type and code.
These items are available only when you select 58 ICMPv6 from the
Protocol list.
If you select Other from the Named ICMPv6 Type list, you need to
enter values in the ICMPv6 Type and ICMPv6 Code fields.
Otherwise, the two fields will take the default values, which cannot
be changed.
Select the operators and enter the source port numbers and
destination port numbers as required.
These items are available only when you select 6 TCP or 17 UDP
from the Protocol list.
Different operators have different configuration requirements for the
port number fields:
•
Not Check—The following port number fields cannot be
configured.
•
Range—The following port number fields must be configured
to define a port range.
•
Other values—The first port number field must be configured
and the second must not.
Only Not Check and Other values are supported.
Select the time range during which the rule takes effect.
397