Item
VLAN configuration example
Network requirements
As shown in
GigabitEthernet 1/0/1 of Switch B.
Configure the PVID of GigabitEthernet 1/0/1 as VLAN 100, and configure GigabitEthernet 1/0/1 to
permit packets from VLAN 2, VLAN 6 through VLAN 50, and VLAN 100 to pass through.
Figure 123 Network diagram
Configuring Switch A
Configure GigabitEthernet 1/0/1 as a trunk port and configure VLAN 100 as the PVID:
1.
a. From the navigation tree, select Device > Port Management.
b. Click Setup.
The page for configuring ports appears.
c. Select Trunk in the Link Type list, select the PVID box, and then enter PVID 100.
d. Select GigabitEthernet 1/0/1 on the chassis front device panel.
e. Click Apply.
Description
•
You can configure a hybrid port as a tagged or untagged member of a VLAN only if
the VLAN is an existing, static VLAN.
Figure
123, trunk port GigabitEthernet 1/0/1 of Switch A is connected to trunk port
117