Telnet Server Ipv6 Acl - HP FlexFabric 7900 Series Command Reference Manual

Default
The Telnet server feature is disabled.
Views
System view
Predefined user roles
network-admin
mdc-admin
Usage guidelines
This command is not supported in FIPS mode.
Administrators can Telnet to the device only when the Telnet server feature is enabled.
Examples
# Enable the Telnet server feature.
<Sysname> system-view
[Sysname] telnet server enable

telnet server ipv6 acl

Use telnet server ipv6 acl to apply an IPv6 ACL to filter IPv6 Telnet logins.
Use undo telnet server ipv6 acl to restore the default.
Syntax
telnet server ipv6 acl [ ipv6 ] acl-number
undo telnet server ipv6 acl
Default
No IPv6 ACL is used to filter IPv6 Telnet logins.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
ipv6: Specifies an IPv6 ACL.
acl-number: Specifies an ACL by its number. If you specify the ipv6 keyword, the value range for this
argument is 2000 to 3999. If you do not specify the ipv6 keyword, the value range for this argument
is 4000 to 4999.
Usage guidelines
This command is not supported in FIPS mode.
You can specify an ACL that does not exist for this command. However, this command takes effect
only after you create the ACL and configure rules for the ACL. For more information about ACL, see
ACL and QoS Configuration Guide.
If you execute this command multiple times, the most recent configuration takes effect.
This command does not take effect on existing Telnet connections.
43