HP FlexNetwork NJ5000 User Manual page 136

Figure 130 Modifying a VLAN interface
Modify a VLAN interface as described in
3.
Click Apply.
4.
Table 50 Configuration items
Item
Select VLAN Interface
DHCP
BOOTP
Manual
Modify
IPv4
Address
Admin
Status
Description
Select the VLAN interface to be configured.
The VLAN interfaces available for selection in the list are those created on the page
for creating VLAN interfaces.
Configure the way in which the VLAN interface gets an IPv4 address.
Allow the VLAN interface to get an IP address automatically by selecting the DHCP
or BOOTP option, or manually assign the VLAN interface an IP address by
selecting the Manual option. In the latter case, you must set the mask length or
enter a mask in dotted decimal notation format.
Select Up or Down from the Admin Status list to bring up or shut down the
selected VLAN interface.
When the VLAN interface fails, shut down and then bring up the VLAN interface,
which might restore the VLAN interface.
By default, a VLAN interface is down if all Ethernet ports in the VLAN are down.
Otherwise, the VLAN interface is up.
When you set the admin status, follow these guidelines:
•
The current VLAN interface state in the Modify IPv4 Address and Modify
IPv6 Address frames changes as the VLAN interface state is modified in the
Admin Status list.
•
The state of each port in the VLAN is independent of the VLAN interface state.
124
Table 50.