Adding An Ipv6 Acl - HP 830 Series Configuration Manual

Poe+ unified wired-wlan switch switching engine web-based
Hide thumbs Also See for HP 830 Series:
Table of Contents

Advertisement

Item
Action
MAC
Address
Filter
COS(802.1p priority)
Type Filter
Time Range

Adding an IPv6 ACL

1.
Select QoS > ACL IPv6 from the navigation tree.
2.
Click the Create tab to enter the IPv6 ACL configuration page.
Figure 473 Adding an IPv6 ACL
3.
Add an IPv6 ACL as described in
Description
Select the action to be performed for packets matching the rule:
Source MAC
Select the Source MAC Address box and enter a source MAC address and
Address
a mask.
Source Mask
Destination MAC
Select the Destination MAC Address box and enter a destination MAC
Address
address and a mask.
Destination Mask
Specify the 802.1p priority for the rule.
Select the LSAP Type box and specify the DSAP and SSAP fields in the LLC
LSAP Type
encapsulation by configuring the following items:
LSAP Mask
Protocol Type
Select the Protocol Type box and specify the link layer protocol type by
configuring the following items:
Protocol Mask
Select the time range during which the rule takes effect.
Permit—Allows matched packets to pass.
Deny—Drops matched packets.
LSAP Type—Indicates the frame encapsulation format.
LSAP Mask—Indicates the LSAP mask.
Protocol Type—Indicates the frame type. It corresponds to the type-code
field of Ethernet_II and Ethernet_SNAP frames.
Protocol Mask—Indicates the protocol mask.
Table
140.
462

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents