Figure 184 The neighbor summary tab
LLDP configuration example
Network requirements
As shown in
the status of the link between Switch A and MED and the link between Switch A and Switch B.
Figure 185 Network diagram
Configuring Switch A
(Optional.) Enable LLDP on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2. By default, LLDP
1.
is enabled on Ethernet ports.
Set the LLDP operating mode to Rx on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2:
2.
a. From the navigation tree, select Network > LLDP.
By default, the Port Setup tab is displayed, as shown in
b. Select port GigabitEthernet1/0/1 and GigabitEthernet1/0/2.
c. Click Modify Selected.
The page shown in
Figure
185, configure LLDP on Switch A and Switch B so that the NMS can determine
Figure 187
appears.
189
Figure
186.