Protocols And Standards; Configuring Poe; Configuring Poe Ports - HP FlexNetwork NJ5000 User Manual

Protocols and standards

The device supports IEEE 802.3af and IEEE 802.3at.

Configuring PoE

Before configuring PoE, make sure the PoE power supply and PSE are operating correctly.
Otherwise, either you cannot configure PoE or the PoE configuration does not take effect.

Configuring PoE ports

Select PoE > PoE from the navigation tree.
1.
Click the Port Setup tab.
2.
Figure 473 Port Setup tab
NOTE:
The Power Max and Power Priority fields are unavailable.
Configure the PoE ports as described in
3.
Click Apply.
4.
Table 160 Configuration items
Item
Select Port
Power State
Table
Description
Select ports to be configured and they are displayed in the Selected Ports area.
Enable or disable PoE on the selected ports.
•
The system does not supply power to or reserve power for the PD
connected to a PoE port if the PoE port is not enabled with the PoE function.
•
If the new PI will cause power overload, the PSE does not supply power to
the PD that connects to the PI.
By default, PoE is enabled on a PoE port.
IMPORTANT:
431
160.