Configuring Queue Scheduling On A Port - HP FlexNetwork NJ5000 User Manual

Table 154 Configuration items
Item
Please select a policy
Direction
Please select port(s)

Configuring queue scheduling on a port

Select QoS > Queue from the navigation tree.
1.
Click Setup to enter the queue scheduling configuration page.
2.
Figure 454 Configuring queue scheduling
Configure queue scheduling on a port as described in
3.
Click Apply.
4.
Table 155 Configuration items
Item
WRR
Queue
WRR
Setup
Group
Weight
Please select port(s)
Description
Select an existing policy in the list.
Set the direction in which the policy is to be applied.
•
Inbound—Applies the policy to the incoming packets of the specified ports.
•
Outbound—Applies the policy to the outgoing packets of the specified ports.
Select one port to which the QoS policy is to be applied on the chassis front panel.
Description
Enable or disable the WRR queue scheduling mechanism on selected ports.
The following options are available:
•
Enable—Enables WRR on selected ports.
•
Not Set—Restores the default queuing algorithm on selected ports.
Select the queue to be configured.
The value range for a queue ID is 0 to 7.
Specify the group the current queue is to be assigned to.
This list is available after you select a queue ID. The following groups are
available for selection:
•
SP—Assigns a queue to the SP group.
•
1—Assigns a queue to WRR group 1.
Set a weight for the current queue.
This list is available when group 1 is selected.
Click to select ports to be configured with queuing on the chassis front panel.
417
Table 155.