Displaying The Ipv6 Active Route Table - HP FlexNetwork NJ5000 User Manual

Figure 236 Creating an IPv6 static route
Create an IPv6 static route as described in
3.
Click Apply.
4.
Table 90 Configuration items
Item
Destination IP Address
Prefix Length
Preference
Next Hop
Interface
NOTE:
To remove a route, access the Remove tab.

Displaying the IPv6 active route table

Select Network > IPv6 Routing from the navigation tree. The Summary tab displays the IPv6
routing table.
The IPv6 routing table contains direct routes that are automatically generated by the system as well
as an IPv6 static route if you have configured one.
Table
Description
Enter the destination host or network IP address, in the X:X::X:X format. The
128-bit destination IPv6 address is a hexadecimal address with eight parts
separated by colons (:). Each part is represented by a 4-digit hexadecimal
integer.
Enter or select the prefix length of the destination IPv6 address.
Set a preference value for the static route. This setting is for route selection
among multiple routes to the same destination.
You can use the default setting because you can have only one IPv6 static
route to one destination.
Enter the next hop address, in the same format as the destination IP address.
Select the management VLAN interface as the outgoing interface.
230
90.