Configuring A Rule For An Advanced Ipv6 Acl - HP FlexNetwork NJ5000 User Manual

Item
Check Fragment
Check Logging
Source IP Address
Source Prefix
Time Range

Configuring a rule for an advanced IPv6 ACL

Select QoS > ACL IPv6 from the navigation tree.
1.
Click the Advance Setup tab.
2.
The rule configuration page for an advanced IPv6 ACL appears.
Description
•
Permit—Allows matched packets to pass.
•
Deny—Drops matched packets.
Select this box to apply the rule to only non-first fragments.
If you do no select this box, the rule applies to all fragments and non-fragments.
Select this box to keep a log of matched IPv6 packets.
A log entry contains the ACL rule number, operation for the matched packets,
protocol number, source/destination address, source/destination port number, and
number of matched packets.
This function is not supported.
Select the Source IP Address box and enter a source IPv6 address and prefix
length.
The IPv6 address must be in a format like X:X::X:X. An IPv6 address consists of
eight 16-bit long fields, each of which is expressed with two hexadecimal numbers
and separated from its neighboring fields by colon (:).
Select the time range during which the rule takes effect.
395