Adding Radius Servers - HP FlexNetwork NJ5000 User Manual

Item
Accounting-On Interval
Accounting-On Attempts
Attribute
Interpretation

Adding RADIUS servers

In the RADIUS Server Configuration area, click Add.
1.
Figure 318 RADIUS server configuration page
Configure the parameters, as described in
2.
Click Apply.
3.
Table 109 Configuration items
Item
Server Type
IP Address
Port
Key
Confirm Key
Description
IMPORTANT:
When enabling the accounting-on feature on a device for the first time, you
must save the configuration so that the feature takes effect after the device
reboots.
Set the interval for sending accounting-on packets. This field is
configurable only after you select the Send accounting-on packets box.
Set the maximum number of accounting-on packets transmission
attempts. This field is configurable only after you select the Send
accounting-on packets box.
Enable or disable the device to interpret the RADIUS class attribute as
CAR parameters.
Description
Select the type of the RADIUS server to be configured. Options include primary
authentication server, primary accounting server, secondary authentication server, and
secondary accounting server.
Specify the IPv4 or IPv6 address of the RADIUS server.
The IP addresses of the primary and secondary servers for a scheme must be different.
Otherwise, the configuration fails.
RADIUS server addresses in the same scheme must use the same IP version.
Specify the UDP port of the RADIUS server.
Specify the shared key for communication with the RADIUS server.
If no shared key is specified, the shared key specified in the common configuration part is
used.
Table 109.
302