Configuring Gts On Ports; Configuring Rate Limit On A Port - HP FlexNetwork NJ5000 User Manual

Configuring GTS on ports

From the navigation tree, select QoS > GTS.
1.
Click the Setup tab, as shown in
2.
Figure 455 GTS
Configure GTS parameters as described in
3.
Click Apply.
4.
Table 156 Configuration items
Item
GTS
Match Type
Queue
CIR
Please select port(s)

Configuring rate limit on a port

Select QoS > Line rate from the navigation tree.
1.
Click the Setup tab to enter the rate limit configuration page.
2.
Figure 455.
Table
Description
Enable or disable GTS.
Select the GTS type. Only queue-based GTS is supported.
Select a queue by its number in the range of 0 to 7.
Specify the CIR, which is the average traffic rate.
Select one or more ports by clicking them on the chassis front panel.
418
156.