Configuring Non-Standard Pd Detection; Displaying Information About Pse And Poe Ports - HP FlexNetwork NJ5000 User Manual

Item
Power

Configuring non-standard PD detection

There are standard PDs and nonstandard PDs. Usually, the PSE can detect only standard PDs and
supply power to them. The PSE can detect nonstandard PDs and supply power to them only if you
enable the PSE to detect nonstandard PDs.
Select PoE > PoE from the navigation tree.
1.
Click the PSE Setup tab.
2.
The page displays the location of all PSEs, and the status of the non-standard PD detection
function.
Figure 474 PSE Setup tab
Enabling the non-standard PD detection function for a PSE
Select Enable in the corresponding Non-Standard PD Compatibility column.
1.
Click Apply.
2.
Disabling the non-standard PD detection function for a PSE
Select Disable in the corresponding Non-Standard PD Compatibility column.
1.
Click Apply.
2.
Enabling the non-standard PD detection for all PSEs
Click Enable All.
Disabling the non-standard PD detection for all PSEs
Click Disable All.

Displaying information about PSE and PoE ports

Select PoE > PoE from the navigation tree to enter the Summary tab.
1.
The upper part of the page displays the PSE summary.
To view the configuration and power information, click a port on the chassis front panel.
2.
Description
When the sum of the power consumption of all ports exceeds the maximum
power of PSE, the system considers the PSE as overloaded.
The power priority for the HPE NJ5000 5G PoE+ switch cannot be changed. If
multiple PIs require power supply during power overload, the one with the
smallest ID takes precedence.
The device reserves 1 W power for each PI to prevent a PD from being powered
off because of power surge.
The maximum PI power of the HPE NJ5000 5G PoE+ switch is 17 W if it is
connected to an AT switch that supports IEEE 802.3at.
The maximum PI power of the HPE NJ5000 5G PoE+ switch is 5 W if it is
connected to an AF switch that supports IEEE 802.3af.
432