Configuring A Rule For An Ethernet Frame Header Acl - HP FlexNetwork NJ5000 User Manual

Item
TCP/UDP Port
Precedence
Filter
Time Range

Configuring a rule for an Ethernet frame header ACL

Select QoS > ACL IPv4 from the navigation tree.
1.
Click the Link Layer Setup tab.
2.
The rule configuration page for an Ethernet frame header IPv4 ACL appears.
TCP Connection
Established
Operator
Source
Port
Operator
Destination
Port
DSCP
TOS
Precedence
Description
Select this box to make the rule match packets used for
establishing and maintaining TCP connections.
These items are available only when you select 6 TCP from
the Protocol list.
Select the operators and enter the source port numbers and
destination port numbers as required.
These items are available only when you select 6 TCP or 17
UDP from the Protocol list.
Different operators have different configuration requirements
for the port number fields:
•
Not Check—The following port number fields cannot be
configured.
•
Range—The following port number fields must be
configured to define a port range.
•
Other values—The first port number field must be
configured and the second must not.
Only Not Check and Other values are supported.
Specify the DSCP value.
Specify the ToS preference.
Specify the IP precedence.
Select the time range during which the rule takes effect.
391
If you specify the ToS
precedence or IP precedence
when you specify the DSCP
value, the specified TOS or IP
precedence does not take
effect.