Local Port Mirroring Configuration Example; Network Requirements - HP FlexNetwork NJ5000 User Manual

Figure 50 Modifying ports
Configure ports for the mirroring group as described in
3.
Click Apply.
4.
A progress dialog box appears.
After the success notification appears, click Close.
5.
Table 23 Configuration items
Item
Mirroring Group
ID
Port Type
Stream
Orientation
Select port(s)

Local port mirroring configuration example

Network requirements

As shown in
packets received and sent by the Marketing department and Technical department.
Description
ID of the mirroring group to be configured.
The available groups were added previously.
Select a Local mirroring group ID to configure ports for the local mirroring group.
Configure ports for a local mirroring group:
•
Monitor Port—Configures the monitor ports for the local mirroring group.
•
Mirror Port—Configures mirroring ports for the local mirroring group.
Set the direction of the traffic monitored by the monitor port of the mirroring group:
•
both—Mirrors both received and sent packets on mirroring ports.
•
inbound—Mirrors only packets received by mirroring port.
•
outbound—Mirrors only packets sent by mirroring ports.
Click the ports to be configured on the chassis front panel. If aggregate interfaces are
configured on the device, the page displays a list of aggregate interfaces below the
chassis front panel. You can select aggregate interfaces from this list and configure them
as mirroring ports of a port mirroring group.
Figure 51, configure local port mirroring on Switch A so the server can monitor the
Table
59
23.