Mc3000 Display In Fault Mode - Lenze AC Tech M3103S Installation & Operation Manual

NOTE
During acceleration and deceleration to the SPEED SETPOINT, the
DRIVE STATUS will show the actual drive speed . When the SPEED
SETPOINT is reached, the DRIVE STATUS will change to RUN (or
STOP if the drive is decelerating to a STOP) .
13 .2 .3 MC3000 DISPLAY IN FAULT MODE
When the drive trips on a fault, the display will automatically change to the FAULT display,
which indicates the FAULT MESSAGE:
In FAULT mode, the ENTER key will toggle the display between four screens: FAULT,
SPEED, % LOAD and VAC . The DRIVE STATUS for these displays will be FAULT . An
example is shown below of the drive in the FAULT mode displaying SPEED .
NOTE
To clear a FAULT, press the STOP key, issue a remote STOP
command at TB-1, or use TB-13D (refer to Parameter 50 - TB13D) .
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
DRIVE
STATUS
RUN > 460 VAC
DIRECTION
(FORWARD)
DRIVE
STATUS
FAULT: OVERLOAD
DRIVE
SETPOINT
STATUS
FAULT > 60.00 HZ
DIRECTION
(FORWARD)
M301L
MOTOR
VOLTAGE
FAULT
MESSAGE
SPEED
SPEED
UNITS
27