First Startup With A New Program Module - Siemens LME7 Series Basic Documentation

Alternately
nfo
>3 s
Alternately
Alternately
Building Technologies
HVAC Products
21.5 First startup with a new program module or
in case of replacement of program module
After 2 minutes the unit change in Loc 138
Basic Documentation LME7...
21 Operation via internal LED
rSt and PrC appears alternately in the display.
The display shows the replacement of the program module.
The signal lamp flashes up red for one time and yellow for
two times alternately.
nfo
Press (>3 seconds)
from data of the program module.
The signal lamp flashes yellow.
The process of 3 seconds is supported by a short flash of
the yellow signal lamp.
Note
nfo
If you press the button <3 seconds, the downloading of
data does not start. To start the restore process again, the
LME7... must be reset by switching mains on / off.
Display shows run during download (restore process) of
program sequence.
End and rSt appears alternately in the display.
The display shows the end of exchange of data.
The signal lamp flashes red.
↓
After restore process, the unit is in lockout position
(LOC 138) automatically and must be reset for opera-
tion!
button for starting the download
110/164
CC1P7105en
13.10.2009