The Dell EMC Networking PoE solution also provides a global usage
threshold feature in order to limit the PoE switch from reaching an overload
condition. The operator can specify the limit as a percentage of the
maximum power.
NOTE:
PoE commands are only applicable to copper ports.
Commands in this Section
This section explains the following commands:
power inline
power inline detection
power inline four-pair forced
power inline management
power inline powered-device
–
power inline
The power inline command enables/disables the ability of the port to deliver
power.
Syntax
power inline {auto|never}
no power inline
•
auto — Enables device discovery and, if a device is found using the
method specified by the power inline detection setting, supplies power
to the device.
•
never — Disables the device discovery protocol and stops supplying
power to the device.
Command Mode
Interface Configuration (Ethernet).
power inline priority
power inline reset
power inline usage-threshold
clear power inline statistics
show power inline
show power inline firmware-version
Switch Management Commands
1991