System Reset - Mitel 430 System Manual

Configuration
5. 6. 3

System reset

Restart of the communication server
A restart reboots the entire communication system. The configuration data is pre-
served.
A new start can be achieved in the following ways:
• With the pilot key on the front panel
See "Carrying out a first start", page 211
• With WebAdmin in the maintenance settings
With the Restart
Notes:
– Never disconnect the communication server from the power supply to trigger a restart. This
can result in data losses and prevent a restart.
– The restart is triggered immediately. All the active call and data connections are interrupted.
First start of the communication server
A first start has the effect of resetting the communication server from scratch. The sys-
tem-specific data such as the system ID, system type, sales channel, licence code,
software generation and IP address of the system are preserved.
A restart can be achieved in the following ways:
• With the pilot key on the front panel
See "Carrying out a first start", page 211
• With WebAdmin in the maintenance settings
With the First start
Notes:
– A first start deletes all the configuration data already stored and replaces it with the default
values of the sales channel. Therefore, back up your configuration data before a first start.
– The first start is triggered immediately. All the active call and data connections are inter-
rupted.
Starting the communication server for the first time and resetting the sales chan-
nel
With the First start and reset sales channel
WebAdmin System reset
delete the sales channel and licence code. During the next start, you will be prompted
for the sales channel and licence code. Note that the licence code is dependent on the
sales channel and that you can no longer use the existing licence code.
Note:
This function is only accessible for Administrators in Expert mode.
178
button in the System
button in the System reset
( =4e) view, you have the possibility for a first start to also
reset( =4e) view.
( =4e) view.
button for the maintenance settings in the
Mitel 415/430 as of R4.1
syd-0580/1.2 – R4.1 – 08.2016