Operations Supervision; Event Message Concept; Event Types - Mitel 430 System Manual

6. 5

Operations supervision

6. 5. 1

Event message concept

The system generates an event message every time an event or error occurs. The
event tables are used to specify how often an event message of a particular type may
be generated by the system over a given period before the event message is sent to
the allocated signal destinations.
There are 7 event tables that can be allocated to 8 signal destinations:
Event tables
1 2
Event type Event type
Signal
destinations
External
System phone
destination
System phone PC on TA / ISDN
with display in
gateway
message group
Fig. 84 Distribution principle for an event message
6. 5. 1. 1

Event types

Event messages have a certain severity level:
ical (red). Many event messages have both a negative impact (error occurred) and a
positive impact (error corrected). Some event messages have no impact and, thus, no
match. Severity level and impact are indicated in the event table.
If an SRM server is indicated as signal destination, the event message severity level
results in a change of system status. This can be seen in the SRM agent and is dis-
played with the corresponding colour (see also section "SRM destination", page 235).
Mitel 415/430 as of R4.1
syd-0580/1.2 – R4.1 – 08.2016
Event message
3 4
Event type Event type
Local destination
Event log
SNMP destination
• PC on TA / ISDN WebAdmin
gateway
• PC on Ethernet
Interface
Operation and Maintenance
5 6
Event type Event type
E-mail ATAS-Interface
Alarm server or
Internal or
other external
external
equipment
endpoints that
can receive
e-mails
Normal (blue), Serious
7
Event type
SRM
(Secure IP Remote
Management)
SRM server
(yellow) and Crit-
213