Mitel 430 System Manual page 145

Socket
Tab. 73 Connection of Ethernet interfaces
RJ45 socket
Settings
The IP address can either be taken from a DHCP server in the IP network or config-
ured statically. If a DNS server is used, the communication server can also be ad-
dressed via its host name.
Tab. 74 Default values, IP address
Parameter
IP address
Subnet mask
Gateway
DHCP
Host name
1) This entry is hidden and does not appear in the parameter's input field
First-start response
The IP addressing after a first start depends on whether a static IP addressing is al-
ready stored on the EIM card from a previous configuration. A static IP addressing (IP
address, subnet mask, gateway) entered manually is stored on the EIM card and re-
mains available after a first start. This means that the communication server remains
accessible via Ethernet interface in the same way as before the first start.
If no IP addressing is entered on the EIM card (e.g. after initial delivery), the communi-
cation server is started with DHCP after a first start. The communication server tries to
log on with the DHCP server and to enter its host name on the DNS server. If logon is
successful the communication server is accessible via the host name.
If the communication server cannot find a DHCP server within 90 seconds, it deacti-
vates the DHCP mode and is then accessible via the standard IP address (see
Tab. 74) with a direct connection.
Mitel 415/430 as of R4.1
syd-0580/1.2 – R4.1 – 08.2016
Pin Signal
1 Tx+
2 Tx–
3 Rx+
4 —
5 —
6 Rx–
7 —
8 —
Parameter value
192.168.104.13
255.255.255.0
0.0.0.0
yes
<Model name>-<MAC-Address>
Example: Mitel430-00085d803100
Installation
1)
145