Equipment On The Odab Options Card; Connection Of A Door Intercom (Tfe) - Mitel 430 System Manual

Installation
4. 7. 5

Equipment on the ODAB options card

The ODAB options card contains the following equipment:
• 1 analogue terminal interface for connecting a door intercom
• Control outputs and control inputs for connecting a door intercom and/or other pur-
poses.
With the aid of jumpers the options card is configured for connecting a door intercom or
provides control inputs and control outputs:
• In the configuration as a door intercom the option card must be fitted to slot IC2
(Mitel 415) or IC4 (Mitel 430). The interfaces are then available at RJ45 sockets
2.1...2.3 (Mitel 415) and 4.1...4.3 (Mitel 430).
• If the option card is used for other purposes, it must be fitted to slot IC1 (Mitel 415)
and IC1...3 (Mitel 430). The RJ45 socket x.1 then provides two control outputs and
the RJ45 socket x.2 two control inputs.
• The possible RJ45 sockets are highlighted in colour in the figure below.
Fig. 62 Interfaces of the ODAB options card
4. 7. 5. 1

Connection of a door intercom (TFE)

If the options card is fitted to slot IC2 (Mitel 415) or slot IC4 (Mitel 430), an analogue
terminal interface is available for connecting a door intercom.
Note:
This analogue terminal interface cannot be used for other purposes as the software does not
support it.
Jumper Configuration
The jumper configuration is shown in the following diagram. Three of the four IO ports
are used for connecting the door intercom. A control input or a control output is availa-
ble for other purposes.
138
Mitel 415/430 as of R4.1
syd-0580/1.2 – R4.1 – 08.2016