Resetting The Ip Address; Thorough Ram Test; Emergency Upload Via Lan - Mitel 430 System Manual

Operation and Maintenance
6. 4. 4. 7

Resetting the IP address

The IP address data is stored on the EIM card and is retained even after a first start.
The following sequence only resets the IP address data of the communication server to
the default values. All the other data is retained.
Requirement:
The system is in "Boot Command Mode", page 205.
1. Press the pilot key several times with a short keypress (SC) until "F2" lights up red.
2. Press the pilot key with a long keypress (LC)
→ After 2 second keypress "F2" lights up green by way of confirmation.
→ The IP address data is reset to the default values once the key is released. The
startup then continues normally.
Default values of the IP address data:
• IP address: 192.168.104.13
• Subnet mask: 255.255.255.0
• Gateway: 0.0.0.0
6. 4. 4. 8

Thorough RAM test

To carry out a thorough RAM test during startup, press the pilot key briefly (SC) during
the orange LED test (pattern[2]). The thorough RAM test lasts for approx. 2 minutes
and is displayed with Pattern [4]. The startup then continues normally.
6. 4. 4. 9

Emergency Upload via LAN

An Emergency Upload is required whenever there is no longer any executable system
software stored on the communication server for whatever reason or if a downgrade to
an older software version is to be carried out.
For this, proceed as described in "Loading new or older system software with System
Search", page 186.
212
Mitel 415/430 as of R4.1
syd-0580/1.2 – R4.1 – 08.2016