Mitel 430 System Manual page 161

3. On the cradle is a small clamp which is flush with the cradle surface. Push it up with
a small flat head screwdriver and remove it from the phone.
4. With the cleat arm towards you and the flat side of the clamp towards the phone turn
the clamp 180° and push it again into the cut-out in the phone cradle. Press in the
clamp till it is flush with the surface and only the feet of the clamp are protruding.
Configuring keys
Configure the keys on analogue phones Mitel 6700 Analogue in the WebAdmin termi-
nal configuration. The phone must be connected during configuration so the key con-
figuration can be stored on the phone immediately. If not, you can load the key config-
uration on the phone after connecting the phone, by clicking
on phone.
To load the key configuration on all connected Mitel 6700 Analogue series phones,
click Update key configuration for all Mitel 6700 Analogue
To load the key configuration stored in the WebAdmin from the connected phone, dial
the function code *#53.
Labelling the phone
1. Remove the cover with the logo on top of the control panel by pressing down slightly
and pushing up.
2. Pull out the designation label on the lugs, label it then push it back again into the
cut-out.
3. Carefully put back the cover with the logo, so that the paper lugs are covered.
Powering the phone
The phone is powered via the FXS line.
Mitel 415/430 as of R4.1
syd-0580/1.2 – R4.1 – 08.2016
Installation
Update key configuration
phones.
161