Hardware Update; Preparations; Licenses And Eim Card - Mitel 430 System Manual

iprfp3G.dnld:
Firmware for OpenMobilityManager (OMM).
6. 3

Hardware update

Hardware maintenance comprises replacing cards, modules and terminals when there
is a defect or for a generation change. Safety regulations must be observed and the
step-by-step procedure must be followed.
6. 3. 1

Preparations

The following preliminary steps apply to interface cards, system cards and system
modules as well as to the mainboard of the communication server itself.
First steps before cards are removed or added:
1. Inform users
2. Disconnect communication server power supply
Inform users
Inform all concerned users if the system has to be put out of operation during working
time.
Tip
To inform users, use the internal messaging system on the system phones.
Disconnect communication server power supply
Shut down the communication server (see "Shutdown Mode", page 206) and discon-
nect it from the power supply.
6. 3. 2

Licenses and EIM card

The license information and IP address of the communication server's Ethernet inter-
face are stored on the EIM (Equipment Identification Module) card. The licence infor-
mation includes:
• The EID (Equipment Identification) serial number of the EIM card
• The sales channel identification CID (Channel Identification)
• Licence code LIC
• System type
Mitel 415/430 as of R4.1
syd-0580/1.2 – R4.1 – 08.2016
Operation and Maintenance
189