Mitel 430 System Manual page 150

Installation
Terminal selection
Two system phones can be connected to a DSI interface (DSI-AD2 only). The system
can only differentiate the two system phones by the position of the address switch on
the phone. The following settings are possible (TSD = Terminal Selection Digit):
• TSD1
• TSD2
Note:
In the following cases
and the port number. In this state the system phone is not ready for operation:
– A terminal has been created at the connected port, but the address selection switch is incor-
rectly set.
– No terminal has yet been created at the connected port.
User allocation
In the configuration each terminal is assigned to a user or a free seating pool. If a ter-
minal has been created at the connected port and the address selection switch is cor-
rectly selected but no user or free seating pool is allocated to the terminal, the system
phone display reads
phone is not ready for operation.
Terminal type
The terminal type is specified along with the configuration of the system. Lines are also
assigned to the line keys there.
Note:
If the terminal type configured is incorrect, the system phone display shows the warning
phone type. On the Office 10 the LED flashes slowly. In this situation, although the system
phone can be used for basic telephone operations, none of the added features will be available.
The terminal type must be entered via WebAdmin or on the terminal via login to the system con-
figuration.
Carrying out a logon on the system phone:
– Office 10: : Press the Foxkey twice.
– All other system phones: Long keypress (long click) on a function key.
appears next. Confirm with Foxkey Yes.
150
Not Configured is displayed along with the node number, the slot number
No Number and indicates the terminal ID. In this state the system
Wrong
Set new phone type
Mitel 415/430 as of R4.1
syd-0580/1.2 – R4.1 – 08.2016