Connecting The Phone - Mitel 430 System Manual

Installation
Warning
The system's reliability can be adversely affected by electrostatic discharges caused by touch-
ing electronic components and elements, and subsequent damage can result. Always observe
the ESD guidelines.
1. Fit foam spacers on the connector side of the Bluetooth module (for the position of
the foam spacer see ➀). The spacer ensures that the Bluetooth module sits se-
curely.
2. Carefully remove the cover for the Bluetooth module on the underside of the phone
using a suitable screwdriver (see ➁).
3. Connect the Bluetooth module. Make sure it is securely fitted (see ➂).
4. Fit the cover for the Bluetooth module back into place and press home until it snaps
into place (see ➃).
Powering the phone
The MiVoice 5360, MiVoice 5361 MiVoice 5370 and MiVoice 5380 system phones are
normally powered via the DSI bus. However there are several reasons that require
powering with a plug-in power supply:
• Long line
• 2 phones on the same bus
• 1 or more expansion key modules on the phone
• Terminal power supply of the communication server is overloaded
Only use the corresponding plug-in power supply unit with FCC connector available as
an option. It is connected either to the phone itself or, when using one or more expan-
sion key modules, on the last expansion key module.
See also
The power available on the DSI bus depending on the line length and the wire diameter, and the
power input of the system phones are described in the chapter "DSI terminal interfaces",
page 115 ff.

Connecting the phone

1. Setting the DSI bus address on the system phone's underside:
– TSD1 = address switch on position 1
– TSD2 = address switch on position 2
2. Plug the connector into the socket-outlet.
3. If the system is configured, test the operation of the system phone.
4. Label the phone as indicated in the operating instructions.
152
Mitel 415/430 as of R4.1
syd-0580/1.2 – R4.1 – 08.2016