Removing And Installing Oil Pump - Audi Q7 2007 Workshop Manual

Audi Q7 2007 !
6
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
–
Apply bead of sealant -arrow- onto clean sealing surface of
sump (bottom section) as illustrated.
•
Width of sealant bead: 2 mm.
Note
The sealant bead must not be thicker than specified, oth-
♦
erwise excess sealant could enter the sump and clog the
strainer in the oil pump.
The sump (bottom section) must be installed within 5 min-
♦
utes after applying sealant.
–
Fit sump (bottom section) and tighten all bolts initially to
5 Nm in diagonal sequence.
–
Tighten bolts on sump (bottom section) in diagonal se-
quence.
–
Install subframe ⇒ Rep. Gr. 40.
–
Install air cleaner housing ⇒ Rep. Gr. 23.
–
Install coolant pipe (left-side)
–
Install poly V-belt tensioner
–
Install poly V-belt ⇒ page
–
Fill up with engine oil and check oil level
Tightening torques
Component
Sump (bottom section) to sump (top sec-
tion)
Engine cross member to longitudinal mem-
ber
Engine mounting to engine support
Oil drain plug
•
1) Renew bolts.
•
2) 180° = one half turn.
1.3

Removing and installing oil pump

Special tools and workshop equipment required
Long-nose grip pliers -VAS 6226-
♦
142
Repair Group 17 – Lubrication
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259
⇒ page 174.
⇒ page 40.
39.
⇒ page 157.
Nm
9
120 + 180°
1)2)
75
50